<< Click to Display Table of Contents >> Navigation:  Connecting Juggler Systems > Juggler Unit Properties > Defaults

Default properties relate to Juggler properties held not in the Project, but in the Juggler module’s firmware on its internal SD card. They include internal IP and MAC addresses, port numbers, the Tx/Rx EDID on each connector, and pixel formats.

The connectors shown for a Juggler node are detected by Compere, and include DisplayPort, HDMI and ST 2110.

Note: If edited, you must click save data and reboot to effect any changes.

Page edited [d/m/y]: 07/11/2023