The Juggler 2 front panel has a touch-screen display, the 7-symbol power button (recessed into the fascia, top right) and a single USB 3 connector to the internal processor that runs Compere and the front panel display. The USB connector is for keyboard access to the internal processor (single board computer running Linux).
Switching on
Juggler 2 must first be connected to an appropriate power source using the supplied IEC power cord. The front panel power button will show a dimly illuminated ‘7’ indicating this connection. Press and release the power button to start the unit. The power button will show bright and the display panel will go through a start-up cycle before settling to the landing page shown above.
Reset
Should you need to reset the internal FPGA board only, the power button can be pressed and held for 3 seconds then released when the ‘7’ light dims. The button will flash for 2 seconds before returning to normal status.
Page edited [d/m/y]: 12/06/2023