Hardware Connectivity

<< Click to Display Table of Contents >>

Navigation:  Setup Instructions for 7thSense 3D Sync using Labjack >

Hardware Connectivity

USB cable: Connect between USB ports on the LabJack unit and the Leader server.

LabJack 3D Sync Cable Assembly

•15-way D Plug connects to the LabJack unit.

•Mini-DIN plug marked ‘M’ to the Leader server graphics card’s 3D sync connector.

•Mini-DIN plug marked ‘S’ to the Follower server graphics card’s 3D sync connector. Where more than 1 Follower server is in use, the Mini-DIN plug marked ‘S1’ goes to the 1st Follower server graphics card’s 3D sync connector, the Mini-DIN plug marked ‘S2’ to the 2nd Follower server, and so on.

•BNC plug to the 3D glasses emitter or projector, as required.

Page edited [d/m/y]: 30/07/2020