<< Click to Display Table of Contents >> Navigation:  »No topics above this level« Using Serial Events for Device Control

Delta has a range of pre-built serial events for to allow sending out serial codes to external devices at set times on the timeline and additionally, you can write more complex serial commands within a Delta Sequence, for example to enable real-time interaction. This document demonstrates how to set up a projector using serial communications and trigger serial events using both direct and sequence methods.

Projector Setup

Connect your projectors using (in this example) RS232 or RS422 as required, for serial communications to the relevant com port (available comports are listed in the Config > Preferences > Communication > Serial tab).

Page edited [d/m/y]: 12/10/2017