Configure Art-Net in DeltaGUI

<< Click to Display Table of Contents >>

Navigation:  Art-Net/DMX Control >

Configure Art-Net in DeltaGUI

Check the configuration in DeltaGUI matches your set-up. In DeltaGUI, select Configure > Preferences and go to ‘ArtNet & DMX’. For the exact representation, see the Delta User Guide for your version on our user portal.

delta-preferences-art-net

Tick to enable ‘Output ArtNet Data’.

Check that the Art-Net NIC IP is the correct NIC to the Enttec box

Type in the correct Universe and SubNet for which Art-Net output should be enabled.

Note: if you tick ‘Enable TestMode’, Delta will send a message out to ALL channels available and so all your devices should respond. Untick this box to stop/reset.

Page edited [d/m/y]: 19/03/2024