Appendix F: Command Line Switches
<< Click to Display Table of Contents >> Navigation: Appendices > Appendix F: Command Line Switches |
Listed in DeltaServer and in DeltaGUI > Help > Command Line Switches.
These switches can be sent to the server application to modify its startup behaviour. Enter them in the Target box of a shortcut.
DeltaServer (affects this run only)
-minimized |
Show the server dialog and playback window minimized. |
-minimizedialog |
Show the server dialog minimized. |
-fullscreen |
Show the playback window fullscreen. |
-delay n |
Delay the server startup for n seconds |
-nopool |
Do not look for pool resources on disk at startup |
DeltaServer (changes also stored for next run)
-master |
Change the current mode to master |
-slave |
Change the current mode to slave. |
-group n |
Change the current group to n |
-smpte_on |
Enable tracking SMPTE |
-smpte_off |
Disable tracking SMPTE |
DeltaGUI
-group N |
Force DeltaGUI to accept only connections from group N |
-selectgroup |
Force DeltaGUI to show a dialog on start to select the single group to allow connections from. |
Note that when starting DeltaGUI with no command line parameters, any other instance of DeltaGUI will be terminated on that PC. However, if you run with Group N or selectgroup command line parameters, this will not happen, so on the same PC you can have one DeltaGUI on Group 3 and another on Group 6 and so on. |