Installation

Unpacking

Unpack your server carefully onto a clean and level surface and examine it for any signs of transit damage. Contact your supplier immediately if anything appears to be damaged, or any parts missing. Please retain all packaging in case of future need to return a server.

Supplied accessories

In your white accessories box, you will have:

•Power cable

•Server motherboard manual

•Windows CD

•Spare front panel air filter

Delta Servers above the Nano series are supplied with:

•2 × rack rails and screws, for the server model supplied

•4 × rubber feet and screws

•2 × SATA cables to connect O/S backup SSD if necessary

Depending on specification, other accessories may include:

•SSD hex caddy key

•spare Genlock ribbon

•HDMI / DVI adapters

•spare blanking plate

•blanking plate with RS232 15 pin D-connector

•4 × fan mounting screws

•Bag of miscellaneous fixings

Lifting

Delta Media Server weight depends on model and specification, the weight is stated on the server’s product label. Larger servers may require a two-person lift, especially when manoeuvring them into a rack. Observe your internal manual handling recommendations to avoid injury.

Rack Mounting

Delta Media Servers (2U and 3U models) are supplied with rack mount slide rails and fixings. Ensure that each server is properly secured to the rack cabinet.

Delta 1U servers should be installed in a rack using a minimum of an M6 rack mount bolt in each of the top and bottom mounting holes on each side of the server’s front panel.

To fit the rails supplied, follow the instructions included with the rails.

For Pico servers mounted in rack trays follow the online user guide.

Rack Stability Precautions

•Ensure the rack is stable (e.g. bolted to the floor) before sliding out the server.

•Do not place objects on equipment projecting from a rack (e.g. do not use as a shelf).

•Only slide out one piece of equipment from the rack at a time.

Connecting External Equipment

To ensure best performance from the server and compliance with relevant EMC regulations, this equipment should only be used with high-quality shielded data and signal cables.

Only equipment and accessories approved to IEC 60950-1 and SELV circuits may be connected to the server. All equipment and accessories shall comply to the relevant standard for the server’s port to which it is connected.

Cleaning

External casing and the front panel should be carefully wiped with a soft cloth and antistatic solution.

Page edited [d/m/y]: 16/12/2020